How to operate the electric distilled water device correctly is a problem that many novices are concerned about; in order to use it better, let's talk about the correct operation method.
1. Place this product in a place where water supply is convenient, and install a leakage-proof and short-circuit switch in the power supply line for this product to use. Make sure that the power supply voltage is consistent with the product, and connect the ground wire well.
2. Connect the tap water with the hose and the water inlet control tap ①, and introduce the water into the condensing cooler④, note: the tap water pressure is relatively high, please do not open the tap water too much, just open a little so that water can flow through, tap water The condensing cooler ④ flows from the return pipe ② into the funnel ⑩ and enters the evaporation pot ⑥. The return water pipe ② should be aligned with the center of the funnel to prevent the pot from turning over. When the water level rises to the glass water level mirror ⑤ of the evaporating pot, the funnel overflow pipe ⑨ Start to overflow, then turn on the power supply, turn on the power for heating for about 10 minutes, the water in the evaporating pot begins to boil, observe the distilled water outlet ③ When it is found that distilled water flows out, adjust the water inlet control faucet ①, and slowly adjust the amount of cooling water entering until the distilled water Smooth and normal outflow, the distilled water hose should not be too long, and do not insert it into the water to prevent the funnel from turning over due to steam blockage.
3. If the water source is natural water and well water, it should be used after chemical treatment and the water quality meets the requirements of GB5749 standard.
4. The condensing cooler is made of metal material, so it should be pre-steamed for 10-16 hours when it is used for the first time, and the distilled water obtained can be used after passing the inspection. In the future, it should be pre-steamed for 30 minutes before each use .
5. After each use, the remaining water should be drained, and the distilled water container should be cleaned and kept clean.
6. The distilled water dispenser hose is user-prepared. The
electric distilled water device is mainly composed of three parts: stainless steel evaporating pot, condenser and electrical device. First, close the drain valve of the electric distilled water device. Open the water source valve, so that the tap water enters the cooler from the water inlet control valve, and then flows into the funnel from the return water pipe, and then pours into the evaporation pot. Until the water level rises to the center of the glass water level gauge, when the water flows out of the overflow pipe and the water level stops rising, temporarily close the water source valve.
English
عربى
